CNC Information

Learn DIY CNC Machining – Hobby CNC Plasma Cutter

Here is a summary of video’s 5-8:   Video 5: In this video Ivan goes through Mach 3 to look over the g-code. He checks to see if we have any problems before we go to the CNC Plasma Cutter.   Video 6: Ivan heads out to the shop and do some work. He shows how he zeros out the cnc plasma cutter and starts cutting the aluminum stomp pad. Once he is done, the stomp pad gets looked over and he notes the slag or dross we will have to grind off next.   Video 7: In this video Ivan rough grinds the cnc stomp pad to remove the dross. It’s a rough grind because later we will use a DA Sander to smooth it all out.

Video 8: During this CNC Video Segment Ivan sands our CNC Stomp Pad with a Dual Action (DA) sander. The CNC Plasma Cut part then is taken over to a stand. Then Ivan starts to look at different traction spikes and how they will look.   Video 9: In this video the holes are drilled in the CNC Stomp Pad. The holes are drilled and then Ivan cleansthem out. We bend the stomp pad while drilling and we must hammer it flat next.   Video 10:Here is the final video in the CNC Stomp Pad Tutorial Video Series. In this video, Ivan goes over the final assembly of the stomp pad. Then we watch as we used double sided tape to adhere it to the snowboard. Finally we take a look at some final photos of the CNC Stomp Pad on the Snowboard.   Ivan has created a unique and personalized video tutorial series that that leaves the viewer anticipating the next video in the series. The complete video series from start to finish can be viewed at:CNC Router . You can always check on Ivan’s website to find his latest CNC projects and Hobby CNC Information.   About CNC Information: CNC Information is an information website that offers users a deeper insight into CNC.